D-sub screw/nut specs

Apogee used metric nuts and screws for all our products until the Symphony I/O which uses Imperial. 

For example, back of Rosetta-800 dsub nut accepts 2.6mm thread from a breakout cable. The imperial size that’s close to this is 440 SAE and that is used on Symphony I/O and later.

If you need these screws, they must be purchased on your own. Use the following information to search for these parts at 3rd-party sites & hardware stores:

Rosetta/16x metric DB25 Hex nuts  

• STANDOFF JACK SCREW 2.6mm 1.75"
• NOT AVAILABLE FOR CUSTOMER PURCHASE

Symphony DB25 Imperial Hex nuts

• STANDOFF JACK SCREW 4-40 3/16”
• NOT AVAILABLE FOR CUSTOMER PURCHASE

Symphony I/O Rack ear screws (into Symphony frame)

• SCREW 6-32 x .375 PH. UNDERCUT FLAT HEAD, BLACK

Top Panel Screws

• 4-40 ¼ PHIL flat-head blk

Rear panel round pan-head screws

• 4-40 ¼ PHIL PAN EXT Black

Symphony I/O module Standoffs

• 4-40 1.5” length, ¼” Hex M-F STANDOFFS Aluminum
• Available Internationally from DigiKey:  https://www.digikey.com/en/products/detail/keystone-electronics/8409/255376

x-series card standoffs - NO LONGER AVAILABLE

• 2 x …. Standoff ⅝ ¼ Hex 4-40 Aluminum
• 1 x …. Mini PCB Support (plastic)

Element Series

• Screws used in plastic end-caps: 4-40X5/16, 6 LOBE TORX FLAT FT MS STAINLESS STEEL
• Screws for optional rack-ears: SCREW, SEMS, 4-40 x 0.50, PPH BLACK